AirTAC 4M220-08 Solenoid Valve
Ordering Code:
Specification:
| Model | 4M110-M5 | 4M110-06 | 4M210-06 | 4M210-08 | 4M310-08 | 4M310-10 | ||
| 4M120-M5 | 4M120-06 | 4 M220-06 | 4M220-08 | 4M320-08 | 4M320-10 | |||
| Fluid | Air to be filtered by 40 µm filter element | |||||||
| Acting | Internal Piloted | |||||||
| Port Size | In=Out=M5 | In=Out=PT1/8″ | In=Out=PT1/8″ | In=Out=PT1/4″ | In=Out=PT1/4″ | In=Out=PT3/8″ | ||
| Effective Sectional Area | 5.5mm2(CV=0.31) | 12.0mm2(CV=0.67) | 14.0mm2(CV=0.78) | 16.0mm2(CV=0.89) | 25.0mm2(CV=1.40) | 30.0mm2(CV=1.67) | ||
| Valve Type | 5 port 2 position | |||||||
| Working-pressure | 0.15~0.8MPa(21-114psi) | |||||||
| Max.Pressure Resistance | 1.5MPa(215psi) | |||||||
| Operating Temperature | -20~70°C | |||||||
| Material of Body | Aluminum Alloy | |||||||
| Lubrication | Not Required | |||||||
| Highest Action Frequency | 5 Cycle/Sec | 4 Cycle/Sec | ||||||
| Weight | 4M110:120g 4M120:175g | 4M210:220g 4M220:320g | 4M310:310g 4M320:400g | |||||
Function Introduction:
1. Pilot-oriented mode:Internal pilot or external pilot.
2. Structure in sliding column mode: good tightness and sensitive reaction.
3. Three position solenoid valves have three kinds of central function for your choice. 4. Double control solenoid valves have memory function.
5. Internal hole adopts special processing technology which has little attrition friction, low start pressure and long service life.
6. No need to add oil for lubrication.
7. It is available to form integrated valve group with the base to save installation space.
8. Affiliated manual devices are equipped to facilitate installation and debugging.
9. Several standard voltage grades are optional.
Installation Instructions:
1. Before installing, be sure the valve hasn’t been damaged via transportation.
2. It’s suggested to use the medium lubricated by 40μm filter element. Be aware of the flow direction and port size.
3. Please notice whether the installation condition accords with technical requirements (such as “voltage”, “actuation frequency”, “working pressure” and “scope of application temperature”), then the equipment can be installed and used.
4. Notice the flow direction of air during installation, P is the air intake, A (B) is the work port and R (S) is the exhaust outlet.
5. Take measure to avoid vibration and frozen.
6. Before using the fittings and tubes make sure they are clean. When connecting to fittings, be sure the PTFE Thread Seal Tape is used correctly.
7. To keep the dust away, please use the silencer for the exhaust ports. Never forget to install dirt-proof boot in air intake and outlet during dismounting.
8. After installing, please use the manual override to test valve first.
